Anycubic Wash and Cure 3

Larger size for improved capacity

Compared to Anycubic Wash & Cure 2.0, Anycubic Wash & Cure 3 has impressively increased the cleaning basket capacity by 100%, now at 3 liters. The total volume of the cleaning container has been expanded to 4 liters. This makes it perfectly suited for LCD (light-curing) 3D printers with a size of 7.3 inches or smaller.

The curing size has been increased by 15%, up to 160*180 millimeters, to accommodate larger and more models for a single finishing session.

Local strengthening, uniform hardening.

The "Innovative Flexicure Gooseneck Lamp Design" increases the energy value by 30,000uW/cm² within a 1-3 cm irradiation range, significantly strengthening the curing effect on subtle areas such as the tops of models and the edges of garments.

By adopting a completely new arrangement of light beads and lens light source, the curing uniformity of Anycubic Wash & Cure 3 has been improved by 20% compared to its predecessor 2.0. This results in a more thorough and comprehensive curing of the entire model.

Double-layer design, IPA saving.

The double-layer PP material cleaning basket is designed to support simultaneous cleaning with the platform. It has two adjustable heights of 100mm and 165mm, providing flexibility to accommodate print platforms ranging in size from 5.9 inches to 7.3 inches. This design maximizes the efficiency of IPA consumption.

Simple operation, quiet and efficient.

Cleaning and curing in dual modes, easily selected with a single click; Improved gooseneck light curing mode can be easily switched on and off with a single click. Infinite rotary knob control, adjustable from 1 to 30 minutes as needed.

Through a more dense structural design and software optimization, the noise interference generated during cleaning and curing is reduced , creating a quieter and more comfortable working environment.

Measured by Anycubic Laboratory, the maximum sound level is <65 dB in the machine's operating mode.