Anycubic Wash and Cure 3 Plus

Compared to Anycubic Wash & Cure Plus, the washing volume of the washing basket has increased by approximately 13.4% to 7.6 liters, and the total volume of the washing bucket is 12 liters, which is suitable for 10.6-inch and smaller light-curing 3D printers.

At the same time, the curing size has increased by 42%, up to φ220*260 millimeters, to accommodate larger and more models for a single post-processing session.

The innovative Flexicure gooseneck lamp design increases the energy value by 30,000 uW/cm²* in the 1~3 cm irradiation area, significantly improving the curing effect on details such as the model's top and the figure's base.

The Anycubic Wash & Cure 3 Plus features a brand new arrangement of lamp beads combined with a lens light source. Compared to the previous generation Anycubic Wash & Cure Plus, it offers a 20% improvement in curing uniformity*. This results in a more thorough and comprehensive overall curing of the model, ensuring better quality and consistency.

The dual-layer PP material cleaning basket supports washing with a platform. It is equipped with two adjustable heights of 150 millimeters and 250 millimeters, allowing for print platforms from 6.6 to 10.6 inches, maximizing alcohol consumption efficiency.

A brand new dual-layer curing platform has been adopted, increasing the number of models cured per cycle and significantly improving curing efficiency.

Cleaning and curing in dual modes, easily selected with one click; Enhanced gooseneck lamp curing mode can be easily switched on and off with one click. Cleaning and curing time can be easily adjusted from 1 to 30 minutes as desired.

Through a more sealed structural design and software optimization, noise interference generated during cleaning and curing is reduced, creating a quieter and more comfortable working environment.