PrimaCreator CR-10S Pro Hardened Steel Nozzle

Premium nozzles from PrimaCreator are a series of replacement nozzles that can make a bigger difference to the result than you might think. Having a high-quality nozzle is like having a sharp pencil, you need it to get a good print.

Features

• High-quality nozzle
• A state-of-the-art factory
• Tolerance is less than ± 0.01 mm

Premium nozzles

Premium nozzles from PrimaCreator are a series of replacement nozzles that can make a bigger difference to the result than you might think. Having a high-quality nozzle is like having a sharp pencil, you need it to get a good print.

High quality

All nozzles from PrimaCreator are made from the best quality brass or steel (depending on type) and finished in a state-of-the-art factory. All nozzles are manufactured with a tolerance of less than ± 0.01 mm. This means that your filament will have a very smooth and clear surface during extrusion, which naturally results in better prints.

• After this process, the material goes through an ultrasonic cleaning bath, after which it is cleaned again and protected from surface oxidation.
• The nozzle will now take shape with millimeter precision, the tolerance is less than ± 0.01 mm.
• The process of removing sharp edges from the nozzles is a very important step, as this constitutes a large part of the result. If too many sharp edges remain on the nozzle, the nozzle will be more prone to clogging. It is therefore important that the nozzle is very smooth and clean before use. In each batch, a few nozzles are selected and cut in half to ensure that all specifications are met and that the surface is in perfect condition.
• The nozzles are then checked one last time and individually packed in a protective box - ready to be shipped to you.
• 0 = 0.20 mm
• 3 = 0.40 mm
• 4 = 0.60 mm
• 5 = 0.80 mm

Recommendations

For best results and optimal print quality, we strongly recommend that you re-level your build plate when changing to a new nozzle. Please note that a PrimaCreator nozzle may be compatible with your printer, but the distance between the nozzle and the build plate must be adjusted.

The process

• The process of manufacturing a PrimaCreator nozzle begins with a selected high-quality material. When the material arrives at the factory, an initial optical inspection is carried out on the material to be used for each batch of nozzles. Then it's time to clamp the material, in other words, to make it into a long rod. In our process, this is done only once, in many other (cheaper) cases this process has to be repeated several times, often up to 3-4 times, and yet you don't get the same results.